Kohler 14RESL 설치 매뉴얼 - 페이지 27

{카테고리_이름} Kohler 14RESL에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Kohler 14RESL 48 페이지. Residential and light commercial generator sets
Kohler 14RESL에 대해서도 마찬가지입니다: 문제 해결 매뉴얼 (8 페이지)

페이지 인쇄

Use a 12-volt group 51 battery with a minimum rating of

500 cold cranking amps at 0_F. The generator set uses

a negative ground with a 12-volt engine electrical

system. See Figure 1-23 for battery connections. Make

sure that the battery is correctly connected and the

terminals are tight.

Note: The generator set will not start and circuit board

damage may occur if the battery is connected in

reverse.

1. To positive (+) terminal on starter solenoid.

2. To ground (--) terminal on or near starter motor.

Figure 1-23 Typical Battery Connection

See the dimension drawing in Section 1.5 for the engine

starting battery location on the air intake side of the

generator set. Standard battery cables provide easy

connection to the battery.

To prevent controller reset during installation, remove

controller fuse F3 before connecting or disconnecting

the battery cables. See Figure 1-22 in Section 1.9 for

the F3 fuse location in the controller's service access

area.

TP-6733 8/11

EZ-273000-J

Use the following procedure to install and connect the

battery.

Battery Installation Procedure

1. Remove controller fuse F3. The fuse is located in

the controller service access area.

Figure 1-22.

2. Ensure that the starting battery is fully charged

before placing the battery in service.

3. Clean the battery posts and/or adapters if

necessary.

4. Install the battery post adapters, if needed.

5. Place the battery in the housing.

6. Connect the positive (+) lead to the engine starting

battery.

7. Connect the negative (--) lead to the engine starting

battery.

8. Install controller fuse F3.

Refer to the generator set operation manual and the

battery

manufacturer's

maintenance instructions.

If the battery is disconnected for service or replacement,

the exercise settings on the RDC/DC controller are lost.

Set the exerciser after installing and connecting the

battery. See Section 1.13, Set Exerciser.

See

instructions

for

battery

Section 1 Installation