Kohler 20RESC 운영 - 페이지 16

{카테고리_이름} Kohler 20RESC에 대한 운영을 온라인으로 검색하거나 PDF를 다운로드하세요. Kohler 20RESC 20 페이지. Residential/commercial generator sets
Kohler 20RESC에 대해서도 마찬가지입니다: 설치 지침 (2 페이지), 설치 및 작동 지침 매뉴얼 (37 페이지)

페이지 인쇄

1. Introduction

RDC2 Controller Features

Six-button keypad

OFF, AUTO, and RUN pushbuttons

Select and arrow buttons for access to system

configuration and adjustment menus

LED indicators for OFF, AUTO, and RUN modes

LED indicators for utility power and generator set

source availability and ATS position (Model RXT

transfer switch required)

LCD display

Two lines x 16 characters per line

Backlit display with adjustable contrast for

excellent visibility in all lighting conditions

Scrolling system status display

Generator set status

Voltage and frequency

Engine temperature

Oil pressure

Battery voltage

Engine runtime hours

Date and time displays

Smart engine cooldown senses engine temperature

Digital

isochronous

steady-state speed at all loads

Digital voltage regulation: ±0.5% RMS no-load to

full-load

Automatic start with programmed cranking cycle

Programmable exerciser can be set to start

automatically on any future day and time, and run

every week or every two weeks

Exercise modes

Unloaded weekly exercise with complete system

diagnostics

Unloaded full-speed exercise

Loaded full-speed exercise (Model RXT ATS

required)

Front-access mini USB connector for Kohlerr

SiteTecht connection

Integral Ethernet connector for the Kohlerr OnCuer

Plus Generator Management System

Section 1 Descriptions and Service Views

governor

maintain

Built-in battery charger

Remote two-wire start/stop capability for connection

of Model RDT or other transfer switches

Diagnostic messages

Displays diagnostic messages for the engine,

generator, Model RXT transfer switch,

programmable interface module (PIM), and load

management device

Over 70 diagnostic messages can be displayed

Maintenance reminders

System settings

System voltage, frequency, and phase

Voltage adjustment

Measurement system, English or metric

ATS status (Model RXT ATS required)

Source availability

ATS position (normal/utility or

emergency/generator)

Source voltage and frequency

ATS control (Model RXT ATS required)

Source voltage and frequency settings

Engine start time delay

Transfer time delays

Voltage calibration

Fixed pickup and dropout settings

Programmable Interface Module (PIM) status

displays

Input status (active/inactive)

Output status (active/inactive)

Load control menus

Load status

Test function

TP-6804 6/15