Kohler K-3082 설치 매뉴얼 - 페이지 8

{카테고리_이름} Kohler K-3082에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Kohler K-3082 29 페이지. Mirrored cabinet
Kohler K-3082에 대해서도 마찬가지입니다: 설치 매뉴얼 (36 페이지), 설치 매뉴얼 (32 페이지), 주택 소유자 매뉴얼 (16 페이지)

페이지 인쇄

#10 x 1-1/4"

Screw

End Cap

6. Attach End Caps

- Locate the spacer blocks and hardware bag.

- Using a piece of masking tape, tape the spacer blocks in location on the outside of the cabinets. Make sure the

pilot holes line up with the recommended holes in the mirror cabinet.

- Position the end caps so the beveled edges are toward the mirror and the front of the cabinet. Align the end caps

so that they are centered to mirror height. End caps should be flush with back of cabinet. Hold or clamp carefully

(protect the surface if clamping) until attachment screws are in place.

- Partially drive four #10 x 1 1/4" screws (provided) through the inside location holes, through spacer block holes

and into the end cap. Tighten screws to secure end cap.

- Place dome cap covers over the screw heads.

7. Attach the Door

- Re attach the door.

- The door is provided with a three way adjustment feature for alignment. Height, level, and fit to the frame gasket

can be adjusted. The use of #2 Phillips screwdriver is recommended.

- If the door is out of level or too close to one side adjust the door left or right with screw #1.

- If the door is too high or too low adjust it up or down with screw #2.

- If the door opens swiftly, squeaks or rubs against the gasket, adjust the door outward with screw #3 .

- Check the door swing. The hinges are provided with a 110 degree black plastic stop to restrict door from swinging

wide.

1010988-2-

Dome Cap Cover

End Cap

Spacer Block

Screw #3

Hinge Adjustment

Screw #1

Screw #2

Kohler Co.