A-Tach Mounts 50366 빠른 시작 매뉴얼

{카테고리_이름} A-Tach Mounts 50366에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. A-Tach Mounts 50366 3 페이지.

A-Tach # 50366

Designed for: Jaguar F Pace 2016 - 2020

For best results, hold the vehicle mount over the place where the mount attaches to the dash BEFORE

attaching the device holder to the vehicle mount to ensure a proper fit with the location. Most often the

mount will appear to be a little too big or small for the intended location. The vehicle mount must be

installed BEFORE a device holder is screwed onto the vehicle mount.

Once screwed together the products are considered used and non-refundable.

The vehicle mount is not designed to be attached and taken off the vehicle repeatedly or on a regular basis.

Once it is attached, it should remain attached until you would like to permanently remove it.

WARNING:

AVOID extreme heat conditions. It can damage the device and the mount.

(1) Clean the area where the mount will attach. The

lower edge of the mount will attach into the seam

illustrated with the arrow in the photo.

(3) Remove the covering from the tape. Use the

seam tool if needed to open the lower seam a little.

ST-1

NOTICE: A-Tach Mounts will not be responsible for

any damage to the vehicle due to the installation

and/or use of the product. The product has been

tested to fit securely to the listed vehicles.

Instructions are provided for your convenience.

You are responsible for the use of the product and

to determine if you have the skill to attach the

product without causing damage to your vehicle or

the product.

Read all instructions and view the photos before

attaching this product.

(2) The upper edge of the mount will attach into

the seam illustrated with the arrow in the photo.

(4) Press the thin lower edge of the mount into the

lower seam.

A-Tach

Mounts