A-Tach Mounts 50366 Quick Start Manual
Browse online or download pdf Quick Start Manual for Automobile Accessories A-Tach Mounts 50366. A-Tach Mounts 50366 3 pages.
Print PageA-Tach # 50366
Designed for: Jaguar F Pace 2016 - 2020
For best results, hold the vehicle mount over the place where the mount attaches to the dash BEFORE
attaching the device holder to the vehicle mount to ensure a proper fit with the location. Most often the
mount will appear to be a little too big or small for the intended location. The vehicle mount must be
installed BEFORE a device holder is screwed onto the vehicle mount.
Once screwed together the products are considered used and non-refundable.
The vehicle mount is not designed to be attached and taken off the vehicle repeatedly or on a regular basis.
Once it is attached, it should remain attached until you would like to permanently remove it.
WARNING:
AVOID extreme heat conditions. It can damage the device and the mount.
(1) Clean the area where the mount will attach. The
lower edge of the mount will attach into the seam
illustrated with the arrow in the photo.
(3) Remove the covering from the tape. Use the
seam tool if needed to open the lower seam a little.
ST-1
NOTICE: A-Tach Mounts will not be responsible for
any damage to the vehicle due to the installation
and/or use of the product. The product has been
tested to fit securely to the listed vehicles.
Instructions are provided for your convenience.
You are responsible for the use of the product and
to determine if you have the skill to attach the
product without causing damage to your vehicle or
the product.
Read all instructions and view the photos before
attaching this product.
(2) The upper edge of the mount will attach into
the seam illustrated with the arrow in the photo.
(4) Press the thin lower edge of the mount into the
lower seam.
A-Tach
Mounts