A-Tach Mounts 50152 빠른 시작 매뉴얼

{카테고리_이름} A-Tach Mounts 50152에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. A-Tach Mounts 50152 2 페이지.

A-Tach # 50152

Designed for: Ford Escape 2020-20__

For best results, hold the vehicle mount over the place where the mount attaches to the dash BEFORE

attaching the device holder to the vehicle mount to ensure a proper fit with the location. Most often the

mount will appear to be a little too big or small for the intended location. The vehicle mount must be

installed BEFORE a device holder is screwed onto the vehicle mount.

Once screwed together the products are considered used and non-refundable.

The vehicle mount is not designed to be attached and taken off the vehicle repeatedly or on a regular basis.

Once it is attached, it should remain attached until you would like to permanently remove it.

WARNING:

AVOID extreme heat conditions. It can damage the device and the mount.

(1) Clean the area where the mount will attach. The

mount will attach onto the two sides of the display

screen. Illustrated with the arrows in the photo.

(2) Remember to rest the back side of the mount

onto the top of the connecting panel. Remove the

covering from the tape. Hook the left edge of the

mount onto the left display frame.

See additional instructions on the back side.

NOTICE: A-Tach Mounts will not be responsible for

any damage to the vehicle due to the installation

and/or use of the product. The product has been

tested to fit securely to the listed vehicles.

Instructions are provided for your convenience.

You are responsible for the use of the product and

to determine if you have the skill to attach the

product without causing damage to your vehicle or

the product.

Read all instructions and view the photos before

attaching this product.

(2) The back of the mount should rest on top of

the connecting panel behind the display.

(4) Press the back of the mount onto the back side

of the display.

A-Tach

Mounts