A-Tach Mounts 50152 Quick Start Manual
Browse online or download pdf Quick Start Manual for Racks & Stands A-Tach Mounts 50152. A-Tach Mounts 50152 2 pages.
Print PageA-Tach # 50152
Designed for: Ford Escape 2020-20__
For best results, hold the vehicle mount over the place where the mount attaches to the dash BEFORE
attaching the device holder to the vehicle mount to ensure a proper fit with the location. Most often the
mount will appear to be a little too big or small for the intended location. The vehicle mount must be
installed BEFORE a device holder is screwed onto the vehicle mount.
Once screwed together the products are considered used and non-refundable.
The vehicle mount is not designed to be attached and taken off the vehicle repeatedly or on a regular basis.
Once it is attached, it should remain attached until you would like to permanently remove it.
WARNING:
AVOID extreme heat conditions. It can damage the device and the mount.
(1) Clean the area where the mount will attach. The
mount will attach onto the two sides of the display
screen. Illustrated with the arrows in the photo.
(2) Remember to rest the back side of the mount
onto the top of the connecting panel. Remove the
covering from the tape. Hook the left edge of the
mount onto the left display frame.
See additional instructions on the back side.
NOTICE: A-Tach Mounts will not be responsible for
any damage to the vehicle due to the installation
and/or use of the product. The product has been
tested to fit securely to the listed vehicles.
Instructions are provided for your convenience.
You are responsible for the use of the product and
to determine if you have the skill to attach the
product without causing damage to your vehicle or
the product.
Read all instructions and view the photos before
attaching this product.
(2) The back of the mount should rest on top of
the connecting panel behind the display.
(4) Press the back of the mount onto the back side
of the display.
A-Tach
Mounts