AQC MAXIVIBE AMV-1140 소유자 매뉴얼 - 페이지 7

{카테고리_이름} AQC MAXIVIBE AMV-1140에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AQC MAXIVIBE AMV-1140 20 페이지.

Shaker type dust collector

ASSEMBLY

8.1

Necessary tools

The following tools and equipement are recommended for the assembly of the dust collector :

• Crane or fork lift

• Swing jib

• Chains

• Shackles

• Eye bolts

• Tapered steel pins

• Ratchet set

8.2

1. Prepare the area where the collector is to be installed. Ensure the area is clear of any obstacle

or debris.

2. Using eye bolts and shackles, lift the dust storage compartment over the area where the

collector is to be installed and gently lower into place.

3. Once this section is firmly into place, use a level to ensure the collector is straight. Install

anchor bolts to secure the collector to the ground.

4. Install a grounding wire.

Apply two (2) strips of adhesive on the flat part of the dust

storage compartment, one (1) strip outside of the holes and

the other inside of the holes (figure 3).

• Spanners and/or wrenches

• Power drill

• Concrete drill bits

• Concrete anchors

• Nuts, washers and bolts

• Self tapping crews

• Silicone tubes

WARNING!