Aqua DET 1 사용 설명서 - 페이지 6

{카테고리_이름} Aqua DET 1에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Aqua DET 1 20 페이지.

Rinse pump (DX pump)

Connect the PVC 4x6 hose (internal diameter 4 mm, external 6 mm) to the suction nipple (1).

Insert the foot filter to the other end of the hose.

Connect the PE 4x6 hose (internal diameter 4 mm, external 6 mm) to the delivery nipple (1).

Insert the Stainless Steel Rinse Injection fitting to the other end of the hose.

Tighten nuts (3 and 4) (see Fig.2).

To fix the pump to the wall use the screws supplied with the pump. Make 4 holes according to dimensions

shown in Fig. 3. Fix the bracket to the wall and then fit the pump to it. Try to keep both the suction and

discharge hose as straight as possible, avoiding any unnecessary bends. Install the pump away from direct

sources of heat and in a dry place at a maximum environment temperature of 40°C. The minimum operating

temperature depends on the liquid dosed and has to remain in a liquid state.

All electrical connections to the AQUA DET1 should first be verified with a meter. AQUA DET 1 is designed

to work with multi-voltage power supply from 24 VAC (set JP1 on B) to 230 VAC (set JP1 on A) 50/60 Hz.

Application of the incorrect voltage will permanently damage the unit and will not covered under the

warranty.

Electrical connection

It's possible to connect the system in two ways: Standard (configuration #1 – with just one cable) like now or

with a separated power supply (configuration #2 – with two cables) just in case of need.

In the dishwashing machine with the electronic control (relays output), we suggest to use the

configuration #2 with two cables.

Configuration #1 – (one cable "Standard")



WARNING: Always disconnect the power supply when servicing the unit

Connect the power supply cable to the dish-washing solenoid valve. When powered both peristaltic pumps

will run at the set flow-rate (set by trimmers inside, see layout circuit board). It is possible to fix a maximum

dosing time of 30 sec for the rinse pump using the DIP SWITCH (see DIP SWITCH USE TABLE).

As an option it could be connected to 2 level probes ADSLG1 on the circuit input. The low level alarm can be

also be used with a Buzzer (see DIP SWITCH USE TABLE).

Layout circuit board

ADSP7000430

07/05/2015

WALL MOUNTING (Fig. 3)

ELECTRIC CONNECTION (Fig. 4)

rev. 2.4

Configuration #2 – (two cables)

6/20