Aqua Computer multiswitch 1.41 소유자 매뉴얼 - 페이지 6

{카테고리_이름} Aqua Computer multiswitch 1.41에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Aqua Computer multiswitch 1.41 12 페이지. Firmware-version 1.06 os- version 1.02

페이지 인쇄

MULTISWITCH

2 2 2 2

4.4. aquabus (I

3-pin add-on connector for optional add-on components by aqua-

computer. Only use cables specified by aqua-computer (not included in

delivery)!

Pin assignment:

4.5. Jumpers

The five positions configure the different functions of the multiswitch™.

Appropriate short-circuit-bridges, so-called „Jumpers", are included in

the delivery.

The individual functions may be derived from chapter 5. Configuration.

4.6. Power outputs 1/2

Screw clamps that allow the connection of up to eight consumer loads

to the power outputs of the multiswitch™. The outputs supply a

maximum of 12 V at a maximal 1 amp per channel. The total load

not be higher than 40 Watts.

not

be higher than 40 Watts.

be higher than 40 Watts. Incorrect use may result in the destruction

be higher than 40 Watts.

of the multiswitch™ and/or the mainboard and further components!

Pin assignment: Terminal strip 1 contact 1:

Terminal strip 1 contact 2:

Terminal strip 1 contact 3:

Terminal strip 1 contact 4:

Terminal strip 1 contact 5:

Terminal strip 1 contact 6:

Terminal strip 1 contact 7:

Terminal strip 1 contact 8:

Terminal strip 2 contact 1:

Terminal strip 2 contact 2:

Terminal strip 2 contact 3:

- 6 -

Pin 3: D+

Pin 4: D-

Pin 5: VCC

C-Bus)

Pin 1: GND

Pin 2: SDA

Pin 3: SCL

Incorrect use may result in the destruction

Aqua Computer GmbH & Co. KG

Gelliehäuser Str. 1, 37130 Gleichen

green wire

white wire

red wire

The total load must

The total load

Output 8 +12 V enabled

Output 8 GND

Output 7 +12 V enabled

Output 7 GND

Output 6 +12 V enabled

Output 6 GND

Output 5 +12 V enabled

Output 5 GND

Output 4 +12 V enabled

Output 4 GND

Output 3 +12 V enabled

must