Aqua Computer multiswitch 1.41 소유자 매뉴얼 - 페이지 7

{카테고리_이름} Aqua Computer multiswitch 1.41에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Aqua Computer multiswitch 1.41 12 페이지. Firmware-version 1.06 os- version 1.02

페이지 인쇄

Terminal strip 2 contact 4:

Terminal strip 2 contact 5:

Terminal strip 2 contact 6:

Terminal strip 2 contact 7:

Terminal strip 2 contact 8:

NOTICE:

•When disabled the output voltage lies below 0,5 V

•When connecting inductive loads (e.g. motors), a self-induction

recuperation diode (Schottky) and a 100 nF capacitor need to be

connected to the consumer to prevent interferences with the

multiswitch™ and other connected devices. In isolated cases further

measures may be required.

•The outputs are not

When connecting capacitive and inductive loads appropriate precaution

measures must be taken.

4.7. LED-outputs

Connection possibilities for up to eight LEDs. The LEDs are operated via

an into the multiswitch™ integrated series resistance of 100 Ω with 5 V.

Ultra-bright LEDs (I

series resistance directly to the outputs, for LEDs with a low forward

voltage the additional series resistance is calculated as follows:

Additional series resistance = ((5 V – forward voltage) / I

Pin assignment:

Pin 1: VCC LED 1

Pin 3: VCC LED 2

Pin 5: VCC LED 3

Pin 7: VCC LED 4

Pin 9: VCC LED 5

Pin 11: VCC LED 6 Pin 12: GND LED 6

Pin 13: VCC LED 7 Pin 14: GND LED 7

not protected against overvoltage or short-circuits!

not

20 mA, U 3 V) may be connected without any

max

Pin 2: GND LED 1

Pin 4: GND LED 2

Pin 6: GND LED 3

Pin 8: GND LED 4

Pin 10: GND LED 5

Aqua Computer GmbH & Co. KG

Gelliehäuser Str. 1, 37130 Gleichen

MULTISWITCH

Output 3 GND

Output 2 +12 V enabled

Output 2 GND

Output 1 +12 V enabled

Output 1 GND

) – 100 Ω

max

- 7 -