AAVIX AGT3420 소유자 매뉴얼 - 페이지 9
{카테고리_이름} AAVIX AGT3420에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AAVIX AGT3420 20 페이지. 20 inch 15amp snow thrower
Assembly
Middle & Upper Handle
1. Connect the lower handle and
middle handle with locking knobs and
bolts. ( Fig. 3)
Fig.3
2. Connect the upper handle and
middle handle with locking knobs and
bolts.
3. Attach the cable-clamp to the
position shown and then attach the
cable. (Fig.4)
Direction Adjustment Lever
1. Remove the screw from the upper
lever. Insert the lower lever into the
upper lever, tighten them with the
screw removed. (Fig.5)
Fig.5
2. Insert the lever bracket into the hole
on the upper handle, tighten it with
flat washer, spring washer and
butterfly nut. (Fig.6)
Fig.6
3. Remove the cotter pin from the gear
lever. Insert the lower lever into the
hole of the gear lever. Then secure it in
place with the cotter pin. (Fig.7)
Fig.7
4. Check the discharge chute by
turning it fully from left to right
Fig.4
(0~180°). The discharge chute should
rotate freely. (Fig.8)
Fig.8
10