Dexter Laundry COIN COMPACT DRYER 운영자 매뉴얼 - 페이지 13

{카테고리_이름} Dexter Laundry COIN COMPACT DRYER에 대한 운영자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dexter Laundry COIN COMPACT DRYER 17 페이지.

TO CHANGE PROGRAMMED VALUES OR ZERO REGISTERS

1. Open the loading door.

2. Unlock the control tray, carefully slide the control tray assembly forward about three

inches. Press the program switch. (See Figure 4 "Top View of Controller") Reinstall

and lock the controller.

The controller is now in the program mode at the "00" step, displaying the hours run by

the lower drum. (Refer to the table defining the steps.)

This value displayed can be reset to "0" or observed and left as is: Pressing the START

switch will advance the controller through the fifteen remaining steps allowing

observation or alteration.

Note that on any program change or reset it is necessary to advance to the next step by

pressing the START switch to enter the revision. Otherwise the value will remain as it

was before the alteration.

Figure 4 - Top View of Controller