Aqua Creek Ambassador F-PPXRD-NA-02 사용자 설명서 - 페이지 8

{카테고리_이름} Aqua Creek Ambassador F-PPXRD-NA-02에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Aqua Creek Ambassador F-PPXRD-NA-02 18 페이지. Pool lift

페이지 인쇄

Ambassador Assembly Instructions

1. Attach seat belt to the seat.

2. Install the Ambassador pool lift onto the three (3)

anchors using the supplied 1/2 inch x 1 1/2 inches

stainless steel hex-head bolts and 1/2 inch stainless steel

washers. Make sure all bolts are tight before using the

lift.

SEE FIGURE 8

3. Apply dielectric grease to the plug terminals,

including the o-ring seal. Plug the handset cable into the

large handset socket on the bottom of the control box.

Press the cord end fi rmly into the socket until you are

sure it is completely in the socket. Failure to fully push

the remote cord into the socket may result in faulty or interrupted operation.

4. Before installing the battery, place it on the charging unit and let it charge for 24 hours. Make

sure the orange "charge" light illuminates when the battery is being charged. When the orange

charge light shuts off , the battery is fully charged.

5. Remove the fully charged battery

from the charger and install it on top

of the control box. The battery will

line up with the control box, and will

'click' when it properly locks in place.

Apply dielectric grease to the plug

terminals, including the o-ring seal,

and then connect the battery cable to

the control box cable.

6. With the lift fully assembled, run

the lift fully out and back in 3-5 times,

without weight, for the lifts "break in"

cycle period.

WHEN NOT IN USE, STORE THE BATTERY ON THE CHARGER!

SEE FIGURE 7

ATTACH

FULLY-CHARGED

BATTERY

CONTROL BOX

1/2" X 1-1/2"

HEX BOLT (3)

1/2" FLAT

WASHER (2)

LOOP ON TOP

FOR EASY ACCESS

THREAD THROUGH

FIGURE 7

SLOTS AND PINCH

TOGETHER TO HOLD

HANDSET

PLUGS INTO

CONTROL BOX

1/2" EXTERNAL

TOOTH WASHER (1)

FIGURE 8

Revised 6/28/18

POOL

WALL

ANCHORS (3)

INSTALLED FLUSH

W/DECK SURFACE