Aqua Creek Ambassador F-PPXRD-NA-02 사용자 설명서 - 페이지 9

{카테고리_이름} Aqua Creek Ambassador F-PPXRD-NA-02에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Aqua Creek Ambassador F-PPXRD-NA-02 18 페이지. Pool lift

Pull-out Legrest Installation Instructions

The PULL-OUT LEGREST ASSEMBLY is designed to fit under the standard Aqua Creek chair, and

is installed inside the 2" square tubing that supports the chair from underneath. Installation is

the same for every lift, Ranger lift is shown in picture below. To install the pull-out leg-rest;

1. With a flat-blade screwdriver, pry off the 2" square plug from the end of the 2" square tube

of the seat arm.

SEE FIGURE 9.

2. Drill a 9/32" hole at the location indicated in

support tube. Drill only through the bottom of the tube. Remove the burrs from the hole before

installing the legrest assembly.

2" SQUARE

PLUG

DRILL

9/32" HOLE

(BOTTOM OF CHAIR SUPPORT TUBE)

(SEE DRAWING TO THE RIGHT)

through the bottom of the chair

FIGURE 10

SEAT

SEAT ARM

FIGURE 9

DRILL

9/32"

(THIS SIDE)

CHAIR SUPPORT TUBE

(BOTTOM VIEW)

FIGURE 10

3/4"

Revised 6/28/18