Aqua Creek F-03EZPL 설치, 조립 및 작동 지침 - 페이지 7

{카테고리_이름} Aqua Creek F-03EZPL에 대한 설치, 조립 및 작동 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Aqua Creek F-03EZPL 12 페이지. Ez pool lift

ASSEMBLY INSTRUCTIONS – EZ POOL LIFT

9/16" Wrench

The EZ Pool Lift arrives with the boom arm attached to the mast. To complete the

assembly, layout all parts needed on a large clean

area.

STEP 1:

Locate the Hydraulic ram and attach the upper end

of the hydraulic ram to the boom with one

(1) 3/8" x 1-3/4" hex head bolt, two (2) 3/8" flat

washers, and one (1) 3/8" nylock nut.

STEP 2:

Connect the lower end of the hydraulic ram to the

mast with one (1) 3/8" x 1-3/4" hex head bolt, two

(2) 3/8" flat washers, and one (1) 3/8" nylock nut.

MAKE SURE THAT THE 3/8" ROD END IS ALWAYS

FULLY SEATED WITH THE MAXIMUM ALLOWABLE

THREAD BEING USED.

STEP 3:

Install lift into previously installed anchor socket in the pool deck. Make sure that the mast

is seated at the bottom of the anchor. Check to ensure easy rotation of the lift in nylon-

lined anchor sleeve.

STEP 4:

Locate the four (4) internal sling support bars

and insert them into the sewn pockets in the

mesh sling.

EZINST-6/27/14

REQUIRED TOOLS

3/4" Wrench

!WARNING!

INTERNAL SLING

SUPPORT BAR

STEP 4

Page 7 of 12