Aqua Creek Products F-802SC2 매뉴얼 - 페이지 12
{카테고리_이름} Aqua Creek Products F-802SC2에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Aqua Creek Products F-802SC2 16 페이지. Lift graph
Aqua Creek Products F-802SC2에 대해서도 마찬가지입니다: 매뉴얼 (2 페이지), 빠른 시작 매뉴얼 (4 페이지)
페이지 인쇄- 1. Page Description
- 1. Anchor Installation: Core-Drill Retro-Fit
- 1. Anchor Installation: Saw-Cut Retro-Fit
- 1. Scout 2 Lift Assembly Instructions
- 1. 6 Actuator
- 2. 2 Scout 2 Components
- 2. Table of Contents
- 2. 24 V Battery
- 2. Battery Test Cable Instructions
- 2. Proper Care of Pool & Spa Lifts
- 2. Scout 2 Parts List
- 2. Seat Assembly Parts List
PROCEDURE
Wash down lift with fresh water and dry with clean, soft,
non-abrasive cloth.
Recharge battery.
Run the lift through a complete test cycle to verify it is
functioning properly.
Visually inspect lift for damage, corrosion, and loose or
missing hardware.
Check all contact points for damage and/or corrosion.
Repair, clean, and apply dielectric grease to all contact
points.
Thoroughly clean lift frame and apply a liberal coat of car
wax to maintain the lift's finish.
Check all Warning and Cautionary labels to make sure they
are not faded or worn. Replace as needed.
PROPER CARE NOTES
• Use only fresh water to wash your lift. Do not wash with pool water.
• Use only clean, soft, non-abrasive cloths to wipe down your lift.
• Do not store lift in pump room or near chemicals.
• Do not allow children to play on or around this lift.
• When cleaning the lift, do not spray water directly on control box or battery.
• The lift may need to be bonded according to local code requirements.
STAIN REMOVAL TIPS:
To remove stubborn stains from finish, spray affected area with Mild Dish Soap, rub
briskly with a 3M Scotch Brite™ pad. Use white epoxy paint to touch up the finish. Apply
wax to protect when dry.
For service and/or replacement parts contact Aqua Creek direct at
12
Copyright © 2017 Aqua Creek Products All Rights Reserved
Proper Care of Pool & Spa Lifts
Toll free: (888) 687-3552
DAILY
WEEKLY
MONTHLY
Revised 5/9/17