Aqua Creek Products F-802SC2 매뉴얼 - 페이지 7
{카테고리_이름} Aqua Creek Products F-802SC2에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Aqua Creek Products F-802SC2 16 페이지. Lift graph
Aqua Creek Products F-802SC2에 대해서도 마찬가지입니다: 매뉴얼 (2 페이지), 빠른 시작 매뉴얼 (4 페이지)
페이지 인쇄- 1. Page Description
- 1. Anchor Installation: Core-Drill Retro-Fit
- 1. Anchor Installation: Saw-Cut Retro-Fit
- 1. Scout 2 Lift Assembly Instructions
- 1. 6 Actuator
- 2. 2 Scout 2 Components
- 2. Table of Contents
- 2. 24 V Battery
- 2. Battery Test Cable Instructions
- 2. Proper Care of Pool & Spa Lifts
- 2. Scout 2 Parts List
- 2. Seat Assembly Parts List
TOOLS REQUIRED:
1/2" WRENCH
9/16" WRENCH
3/4" WRENCH
1.
Lift the Scout MAIN ASSEMBLY from the shipping container. Insert the 1.9" [48mm] post of the
MAIN ASSEMBLY into the deck anchor (FIGURE A, PAGE 5). Ease the MAIN ASSEMBLY down until
it rests on the deck surface. Rotate the base until the fi xing anchor-tab lines-up with the fi xing
anchor. Install the 1/2" x 2" hex bolt and washer to hold down the lift. Tighten the bolt.
2.
Remove the shipping strap and all packing from the ACTUATOR. Connect the LIFTING ARM
between the mast and the ACTUATOR (FIGURE D). Tighten nylock nuts (PHOTO 1 & PHOTO 2).
PHOTO 1
PHOTO 3
NOTE: Be careful not to over-tighten bolts.
Over-tightening can cause damage and
compromise the safety of your lift.
Copyright © 2017 Aqua Creek Products All Rights Reserved
Scout 2 Assembly Instructions
3/16" ALLEN WRENCH
1/4" ALLEN WRENCH
PHOTO 2
WARNING:
NEVER LIFT THE MAIN ASSEMBLY
USING THE LINEAR ACTUATOR AS A HANDLE! USE
AT LEAST TWO PEOPLE TO LIFT. USE A TRANSPORT
CART IF AVAILABLE.
3/8"-16 NYLOCK NUT
3/8" FLAT WASHER
A
SHOULDER BOLT
B
B
LINEAR
ACTUATOR
NOTE: The LIFTING ARM is easily fl ipped
around the wrong way. Make sure the end
marked "B" is towards the mast, as shown.
1/2" X 2 3/4"
('B' END: SEE NOTE)
5/16"-18 NYLOCK NUT
5/16" FLAT WASHER
3/8" X 2"
SHOULDER BOLT
SCOUT LIFTING ARM
(LONG END: SEE NOTE)
D
FIGURE D
Revised 5/9/17
7