Dexter Laundry WCVD-WN Series 프로그래밍 매뉴얼 - 페이지 2

{카테고리_이름} Dexter Laundry WCVD-WN Series에 대한 프로그래밍 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dexter Laundry WCVD-WN Series 6 페이지. Opl washers
Dexter Laundry WCVD-WN Series에 대해서도 마찬가지입니다: 예방적 유지 관리 (2 페이지)

페이지 인쇄

0 to 15 minutes for Prewash, Rinse1 and Rinse 3 to 15 minutes for Wash and Final Rinse. For the

baths that can, if the time is set to zero, then that bath will be eliminated from the cycle.

HH – hot, CH – warm, CC – cold, EE – no water. The owner can set the bath default. For the wash

bath, the default is over ridden for that cycle by the customer when the temperature is selected.

LO – low The owner can change the displayed value, but for a coinwasher only LO will be put into

the cycle.

The selections are "d" for delay the bath time until water level is reached or "t" for decrement bath

time during the ﬁ ll.

0 to 10 minutes for Prewash, Wash, Rinse1 and Rinse2 1 to 10 minutes for Final Spin.

The owner can change the displayed value, but for a coin washer only 0 will be put into the cycle.

Washer 6 Default Cycles (Preset at Factory)

There are 6 pre programmed baths on the control which are set up at the factory. The

formulas for each are shown on the following pages. Each of these 6 programs can be

adjusted and saved as the owner needs.

Part # 8533-075-001 6/13

Bath Cycle Time "ct"

Bath Water Temperature "t"

Bath Water Level "L"

Bath Delay Fill "dF"

Bath Spin Time "S"

Bath "IS"