Aqua Creek Products Mighty Voyager 사용 설명서 - 페이지 7

{카테고리_이름} Aqua Creek Products Mighty Voyager에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Aqua Creek Products Mighty Voyager 14 페이지. Portable lift

Mighty Voyager Fixing Kit Installation Instructions
• Core-drilling rig
• 1-1/4" diameter core-drill
• 3/4" wrench or socket
NOTE: Fixing Kit installation is only required for ADA applications.
1.
Determine the location of the anchor insert, allowing for the ADA compliant clear
deck space. (see FIGURE 1, page 4)
2.
Mark the location for the 1-1/4 inch x 4 inch deep anchor hole. Using a core-drill,
drill a 1-1/4 inch diameter, 4 inch deep hole at the marked location.
3.
Dry-fi t the anchor insert to make sure it fi ts fl ush with the deck surface.
4.
Fill the hole 1/2 full with epoxy (or equivalent). Install the anchor insert fl ush with
the deck surface and clean off any excess. Allow 24 hours for the epoxy to cure.
5.
Roll the portable cart over the installed anchor. Align the anchor with the U-bracket.
6.
Drop the fi xing bolt into the U-bracket and, by hand, start to thread into the anchor
insert. If needed, adjust the alignment of the lift.
7.
When properly aligned, complete threading with a 3/4 inch wrench or socket.
Tighten until the bolt just touches the fl at washer. DO NOT OVERTIGHTEN.
U-BRACKET
Copyright © 2020 Aqua Creek Products All Rights Reserved
TOOLS REQUIRED:
• 2-part construction epoxy or equivelent
• Tape measure
• Marking pen
1/2" X 2 1/2" HEX BOLT
1/2" FLAT WASHER
PVC ANCHOR INSERT
7
Revised 10/21/20