Aqua Creek Products AT053426 운영자 매뉴얼 - 페이지 6

{카테고리_이름} Aqua Creek Products AT053426에 대한 운영자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Aqua Creek Products AT053426 8 페이지.

Once the cable has been completely strung on both sides, check that the bump stop on the truck

weight rails is 1-2 inches above the stop tube. This is to ensure there is proper tension on the

cable so that it does not pop out of any of the pulleys while in use. If adjustment is needed on

either or both sides, tighten or loosen the nut that is part of the hook where the end of the cable

is attached. See FIG. 4 below.

ProTone Main Wire Assembly

MAIN WIRE ROPE

ADJUST THIS NUT

TO ADD OR RELEASE

TENSION ON THE CABLE

BUMP STOP SHOULD BE 1-2 INCHES

ABOVE THIS STOP TUBE.

TRUCK WEIGHT RAIL

FIGURE 3

FIGURE 4

Revised 12/14/20