Dexter Laundry WCAD Series 프로그래밍 지침 매뉴얼 - 페이지 6

{카테고리_이름} Dexter Laundry WCAD Series에 대한 프로그래밍 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dexter Laundry WCAD Series 6 페이지. Vended washers

Coin Washer Default Cycle (Preset at Factory)

The following table shows the complete details for the coin washer default cycle.

Bath

Bath Cycle Time (min.)

Prewash

Wash

Rinse 1

Rinse 2

Final Rinse

*NOTE:

These default values are preset and cannot be changed.

Rapid Advance Mode

To enter the Rapid Advance mode, push and hold the Cold water temperature button and then push the

programming button on the controller. There will be no observed change to the washer or the display. The

Rapid Advance mode can be entered from either the Idle mode or during the cycle. To rapid advance to

the next step in the wash cycle, push both Start and Warm temperature buttons at the same time. The

display will show an "Ad" (advance) in the display. The washer will advance to the next bath segment. The

water will drain before the advance will occur.

To exit the Rapid Advance mode, push and hold the Cold temperature button for 5 seconds or more.

NOTES:

Step 1: When the Rapid Advance mode is used, the cycle time will no longer be correct.

Step 2: By skipping steps with rapid advance, the door may not open immediately at the end of the

cycle.

This control has a battery that allows memory retention in case of main power loss. The battery may need

replacing if time of day options are not functioning properly.

Remove power from machine and lockout safely.

Remove battery from socket on circuit board and reinstall new battery (#8612-001-001).

CAUTION:

nal clock and not allow re-startup of internal clock, possibly causing programming trouble.

Part # 8533-073-001 11/11

Water Temp.

Do not soft reset this machine when installing new battery. This will reset inter-

Water Level*

Delay Fill

Spin Time (min.)

IS *