Dexter Laundry WCAD Series 프로그래밍 지침 매뉴얼 - 페이지 4

{카테고리_이름} Dexter Laundry WCAD Series에 대한 프로그래밍 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dexter Laundry WCAD Series 6 페이지. Vended washers

To change the washer cycle, push the Hot temperature button once. The display will change to "C 1",

indicating cycle one is selected. The temperature buttons are used to make changes to the program. In

the program mode, these buttons will do as displayed in drawing below.

When the display shows "C 1", push Enter. The display will show "b " and the PreWash mode light will

blink. Use the Up/Down buttons to move to the bath that will be changed. As Up/Down buttons are

pushed, the next bath mode light turns on.

When the Up button is pushed, the lit bath mode changes from Prewash to Wash. With each additional

push of the Up button, the lit bath mode changes from left to right: Prewash, Wash, Rinse and Final Rinse.

As there are two possible Rinse bathes, for Rinse 1 the Rinse LED and the display changes to "b" in the

left digit and "r1" in the two right hand digits. For Rinse2, the display changes to "b" in the left digit and

"r2" in the two right hand digits. Note that the Spin light is not used. When the Down button is pushed,

the lit bath mode changes from Prewash to Final Rinse, etc.. There is a wrap around feature on the display

in both directions.When the desired bath mode light is on, push Start.

Bath Cycle Time

The selected bath LED begins to blink. The display shows the letters "ct" in the left two digits and the

bath cycle time in the right two digits. Again the up/down buttons change this value. The range is shown

below. If zero time is entered, then the bath will be skipped and the program will return to the bath

selection. When the desired cycle time is selected, push Start.

Bath Water Temperature

The display shows the letter "t" in the left digit and the letters "CC" appear in the right two digits. This is

the bath water temperature. The selection choices are shown below but for the coin washer the value is

defaulted to CC. As it is not selectable with a coin washer, the owner pushes Start to continue.

Bath Water Level

The display shows the letter "L" in the left digit and the letters "LO" appear in the right two digits. This is

the bath water level. The selection choices are shown below but for the coin washer the value is defaulted

to LO. As it is not selectable with a coin washer, the owner pushes Start to continue.

Bath Delay Fill

The display shows the letters "dF" in the left two digits and the letter "t" appears in the right digit. This

is the bath delay ﬁ ll. The selections are "t" for decrementing bath time during the ﬁ ll or "d" for delay the

bath time until water level is reached. When the desired selection is made, push Start.

Bath Spin

The display shows the letter "S" in the left digit and the bath spin time in the right two digits. Again the

up/down buttons change this value. The range is shown below. When the desired spin time is selected,

push Start. The display shows the letters "IS" in the left two digits and the injection selection appears in

the right digit. For the coin washer the default value is "0" and cannot be changed. Push COLD.

The display will show "b" and the bath LED lights will stop blinking. Again use the up/down buttons change

the bath selection. To exit the programming mode, push and hold COLD until price is displayed. The cycle

will be stored when exiting the programming mode.

Part # 8533-073-001 11/11