AB Marine Gori 설치 지침 매뉴얼 - 페이지 5

{카테고리_이름} AB Marine Gori에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AB Marine Gori 8 페이지. 2-blade saildrive propeller

[Gori 2-Blade Saildrive Propeller Installation and Maintenance Instructions, 6/21/2022]

Do not use oil or any petroleum product on Flexible Bushing!

1. Remove the two (7&8) M8 Allen screws per blade pin. There are two (2) Allen screws per blade pin, a

total of four(4). Push the two blade pin (3) out using a wooden dowl - note blades, pins and hub are

numbered for re-assembly.

2. Unscrew the nut-locking bolt (4.1) with the washer (4) using a 5mm Allen key (19). Older models may

have a cotter pin which needs to be removed.

3. Unscrew the two (2) M5 Locking setscrews in the face of the integrated nut washer. Note: this is on

2020+ models.

4. Unscrew the shaft nut (5) counterclockwise using required socket (See above). It may be necessary to

lock the output shaft when undoing the shaft nut. To do this either put the engine into reverse or use

a strap wrench to hold the inner hub (1).

5. Pull/slide the hub (1), off the output shaft spline. Ensure that the Saildrive spacer supplied with the

saildrive unit is in place at the forward end of the output shaft.

This should be done if more than 50% of the zinc (17), has been eroded away.

1. Remove the 4 x Allen-head bolts (11) and remove the old zinc.

2. Clean the surface of the propeller hub to ensure a good clean contact between the hub and the new

zinc

3. Install the new zinc (10) using the Loctite 243 (supplied) on each of the 4 x Allen-head bolts

Removing the Propeller

Distributed By

AB Marine, Inc ▪ 747 Aquidneck Ave ▪ Middletown ▪ RI 02842

Tel: 401-847-7960 ▪ Fax: 401-849-0631

Email:

▪ Website: www.AB-Marine.com