Avnet ZUBOARD 1CG 시작하기 매뉴얼 - 페이지 13

{카테고리_이름} Avnet ZUBOARD 1CG에 대한 시작하기 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Avnet ZUBOARD 1CG 14 페이지.

Installing and Licensing AMD Software

Install Vivado™ ML Standard Edition

The Zynq device on the ZUBoard 1CG is supported in Vivado Design Suite ML Standard

Edition. Version 2021.2.1 or later is required for the on-board USB-JTAG/UART circuit to work.

See

https://www.xilinx.com/products/design-tools/vivado.html

This software can be downloaded online at:

www.xilinx.com/support/download/index.htm

http://www.xilinx.com/getlicense

If a full seat of Vivado Standard or Enterprise Edition has already been installed, then no further

software will be needed. Please check online for any updates at:

www.xilinx.com/support/download/index.htm

For detailed instructions on installing and licensing the AMD tools, please refer to the latest

version of Vivado Design Suite User Guide Release Notes, Installation, and Licensing

(UG973). The 2022.2 version is available on the AMD Xilinx website at:

https://docs.xilinx.com/r/en-US/ug973-vivado-release-notes-install-license

CE certification is necessary for system level products in those countries governed by this

regulatory bodies.

Because Avnet boards are intended for evaluation kits only and destined for professionals (you)

to be used solely at research and development facilities for such purposes, they are considered

exempt from the EU product directives and normally are not tested for CE or FCC compliance.

If you choose to use your board to transmit using an antenna, it is your responsibility to make

sure that you are in compliance with all laws for the country, frequency, and power levels in

which the device is used. Additionally, some countries regulate reception in certain frequency

bands. Again, it is the responsibility of the user to maintain compliance with all local laws and

regulations.

Page 13