Avnet ZUBOARD 1CG 시작하기 매뉴얼 - 페이지 9

{카테고리_이름} Avnet ZUBOARD 1CG에 대한 시작하기 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Avnet ZUBOARD 1CG 14 페이지.

9. Once VIN is established press the Power Switch (SW7) to turn the board ON. The green

LED (D23) will illuminate to indicate Power Good.

Note: When the micro-USB is connected to the Host Windows PC an Orange LED (D24 –

JTAG/UART) will illuminate showing communication to the host PC.

10. Connect Ethernet cable to connector (J11). And then to either the host Windows PC or

Router attached to host Windows PC.

11. Launch the Tera Term Application, open SETUP menu, select SERIAL PORT, select Port

assigned to ZUBoard 1CG (typically the largest number) and ensure the other settings

match shown below. Press the RESET button (SW6) to reset the board so you can see

the boot sequence.

Figure 5 – COM Port Settings for USB-UART Terminal

Page 9