AB Quality 1794-IB16 설치 지침 매뉴얼

{카테고리_이름} AB Quality 1794-IB16에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AB Quality 1794-IB16 17 페이지. 24v dc flex i/o digital input modules

Installation Instructions

24V dc FLEX I/O

16 Sink Input Module

(Cat. No. 1794-IB16)

Module Installation

This module mounts on a 1794 terminal base unit.

1. Rotate keyswitch (1) on terminal base unit (2) clockwise to position 2

as required for this type of module.

2. Make certain the flexbus connector (3) is pushed all the way to the left

to connect with the neighboring terminal base/adapter. You cannot

install the module unless the connector is fully extended.

3. Make sure that the pins on the bottom of the module are straight so

they will align properly with the connector in the terminal base unit.

If you remove or insert the module while the

WARNING

backplane power is on, an electrical arc can occur.

This could cause an explosion in hazardous location

installations. Be sure that power is removed or the

area is nonhazardous before proceeding.

4. Position the module (4) with its alignment bar (5) aligned with the

groove (6) on the terminal base.

5. Press firmly and evenly to seat the module in the terminal base unit.

The module is seated when the latching mechanism (7) is locked into

the module.

FLEX I/O is a trademark of

Publication 1794 IN072C-EN-P - October 2001

Rockwell Automation