Deye SUN-8K-SG01LP1-US/EU 사용자 설명서 - 페이지 6

{카테고리_이름} Deye SUN-8K-SG01LP1-US/EU에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Deye SUN-8K-SG01LP1-US/EU 20 페이지. Hybrid inverter

14 mm

(0.55 in.)

52~60mm

[(2.05 in.)to(2.36 in.)]

3.3 Battery connection

For safe operation and compliance, a separate DC over-current protector or disconnect

device is required between the battery and the inverter. In some applications, switching

devices may not be required but over-current protectors are still required. Refer to the

typical amperage in the table below for the required fuse or circuit breaker size.

Model

Wire Size

5/6/7.6/8Kw

2AWG

Chart 3-2 Cable size

Cable(mm )

Torque value（max）

24.5Nm

- 07 -

All wiring must be performed by a professional person.

Connecting the battery with a suitable cable is important for safe and

efficient operation of the system. To reduce the risk of injury, refer to

Chart 3-2 for recommended cables.

Please follow below steps to implement battery connection:

1. Please choose a suitable battery cable with correct connector which can well fit into the

battery terminals. 2. Use a suitable screwdriver to unscrew the bolts and fit the battery

connectors in,then fasten the bolt by the screwdriver,make sure the bolts are tightened

with torque of 24.5 N.M.

2. Nm in clockwise direction,make sure polarity at both the battery and inverter is

correctly connected.

3. In case of children touch or insects go into the inverter,Please make sure the inverter

connector is fasten to waterproof position by twist it clockwise.

Installation must be performed with care.

Before making the final DC connection or closing DC breaker/disconnect,

be sure positive(+) must be connect to positive(+) and negative(-) must be

connected to negative(-). Reverse polarity connection on battery will damage

the inverter.

- 08 -