aqua greek products F-105LAR-01 지침 - 페이지 3

{카테고리_이름} aqua greek products F-105LAR-01에 대한 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. aqua greek products F-105LAR-01 3 페이지.

3. Orient the pull out legrest as shown below and slide the plastic guide/spacer into the chair support

tube. Tap the palstic guide/spacer with a hammer or mallet until ush with the end of the support

tube. The threaded hole in the bottom of the plastic guide/spacer should line up with the hole

drilled in the support tube. Install the washers and 1/4"-20 x 1/2" cap screw from underneath and

tighten until snug.

1" SQ. TUBE

PLASTIC

GUIDE/SPACER

The PULL-OUT LEGREST is now ready to use. However, before using, slide the legrest in and out, and put

the pad up and down to make sure everything works smoothly.

LEGREST

STOWED

SLIDE FORWARD AND INSERT PIN TO LOCK IN "UP" POSITION

SLOT

CHAIR SUPPORT TUBE

PULL OUT LEGREST

PLASTIC GUIDE/SPACER

FLUSH WITH 2" SQ. TUBE

1/4" FLAT WASHER

1/4" LOCK WASHER

1/4" X 1/2" CAP SCREW

LEGREST

OUT

LEGREST

OUT & UP

Revised 2/28/18