Aqua Logic DSHP Series 설치 및 운영 지침 매뉴얼 - 페이지 4

{카테고리_이름} Aqua Logic DSHP Series에 대한 설치 및 운영 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Aqua Logic DSHP Series 11 페이지.

Installation Instructions:

1. Place the heat pump on a level concrete or metal pad with at least two (2) feet of space around

the unit to allow room for access to the unit for air flow and maintenance. If the heat pump is to

be mounted outdoors, it must be placed in to a weather proof housing to protect from direct

weather and rain.

2. Connect the plumbing from the tank to the heat exchanger FPT PVC water fittings on the front

of the heat pump. Be careful not to over tighten the plastic fittings.

3. Install flow switch (if supplied) either on the water inlet or outlet side with at least 12 inches of

straight pipe on the inlet side and 6 inches on the outlet side.

4. Submerse into tank the ½" titanium temperature sensor probe in

the water.

Optional titanium dry sensor well: Install in the water inlet

plumbing of the heat pump.

5. Check for water leaks.

6. Plug-in the temperature controller to the flow switch (optional) and then to the heat pump.

If hard wired, the installation must proceed in accordance with national building and

electrical codes by qualified technicians only.