Bil-Jax ET 1500 작동 및 서비스 매뉴얼 - 페이지 11

{카테고리_이름} Bil-Jax ET 1500에 대한 작동 및 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Bil-Jax ET 1500 14 페이지. Bil-jax escalate trailer et 1500 - operation and service manual

페이지 인쇄

Tire Maintenance

At least once each week, use an accurate tire

pressure gage to check the air pressure in both

trailer tires. Inflate to the pressure recommended by

the tire manufacturer (located on the tire).

Low or uneven tire pressures will not properly

support a loaded trailer and could lead to premature

tire wear.

When replacing tires, it is important to use a tire of

appropriate size and load rating (530-12).

Failure to maintain proper torque on the lug nuts

may result in the wheel shearing off of the trailer,

possibly causing an accident and seriously

damaging the equipment.

Lubrication (every 6 months)

Lubricate the following parts with clean motor oil

where shown.

For additional winch operating and service instructions, refer to the Winch Owner's Manual. The Winch

Owner's Manual is in the storage tube at the front of the trailer.

NOTE: Be sure that no grease is applied to brake pad.

Wheel Bearings

Hitch

It is extremely important to apply and maintain

proper wheel mounting torque on your axle.

Wheel nuts should be retorqued after 50 miles

and 100 miles and periodically there after.

The tightening of the lug nuts should be torqued

in the sequence above.

Lug nuts should be torqued in stages:

Stage 1

25 Ft-Lbs

This procedure should be followed after each

time the tire is removed.

or wheel bearing grease

Jack

Deck Latch

Wheel Torque Requirements

Stage 2

60 Ft-Lbs

Winch

Bumper Bar

SERVICE

Stage 3

100 Ft-Lbs

M a

x .