Bil-Jax ET 1500 Manual de operação e serviço - Página 11

Procurar online ou descarregar pdf Manual de operação e serviço para Veículo utilitário Bil-Jax ET 1500. Bil-Jax ET 1500 14 páginas. Bil-jax escalate trailer et 1500 - operation and service manual

Tire Maintenance

At least once each week, use an accurate tire
pressure gage to check the air pressure in both
trailer tires. Inflate to the pressure recommended by
the tire manufacturer (located on the tire).
Low or uneven tire pressures will not properly
support a loaded trailer and could lead to premature
tire wear.
When replacing tires, it is important to use a tire of
appropriate size and load rating (530-12).
Failure to maintain proper torque on the lug nuts
may result in the wheel shearing off of the trailer,
possibly causing an accident and seriously
damaging the equipment.
Lubrication (every 6 months)
Lubricate the following parts with clean motor oil
where shown.
For additional winch operating and service instructions, refer to the Winch Owner's Manual. The Winch
Owner's Manual is in the storage tube at the front of the trailer.
NOTE: Be sure that no grease is applied to brake pad.
Wheel Bearings
Hitch
It is extremely important to apply and maintain
proper wheel mounting torque on your axle.
Wheel nuts should be retorqued after 50 miles
and 100 miles and periodically there after.
The tightening of the lug nuts should be torqued
in the sequence above.
Lug nuts should be torqued in stages:
Stage 1
25 Ft-Lbs
This procedure should be followed after each
time the tire is removed.
or wheel bearing grease
Jack
Deck Latch
Wheel Torque Requirements
Stage 2
60 Ft-Lbs
Winch
Bumper Bar
SERVICE
Stage 3
100 Ft-Lbs
M a
x .
C
11