Aqua Medic 83416004 운영 매뉴얼 - 페이지 5
{카테고리_이름} Aqua Medic 83416004에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Aqua Medic 83416004 19 페이지.
페이지 인쇄
Programmable light control with three control outputs for one spot each with two channels (Aqua
Medic LEDspot and LED FA).
1.
Technical Data
- 12 V DC safety voltage
- dimensions: 11.0 x 6.0 x 2.5 cm
2.
Unpacking
On unpacking, please check the light control immediately for any damage. In case of any problems, please contact
your dealer directly.
3.
Included in shipment
spot control
power supply unit
A 'Y'-cable for connecting two lights to one light connection is available as an accessory.
4.
Safety instructions
-
When working in the aquarium, always disconnect all units from the power supply system before putting your
hands into the water. Connect all units to the mains via a residual current device with a maximum residual
current of 30 mA.
-
Suitable for indoor use only.
-
Protect the power supply and controller from moisture, splash and condensate.
-
Not suitable as a toy for children.
5.
Installation
5.1. Programming
The spot control may only be connected to the designated socket (pict. No. 1). The internal battery will need to
be charged before use. After charging, the controller can be switched on independently from the light by pressing
the "M" and "OK" buttons simultaneously.
Fig. 1: spot control connections: 1 – 3: control outputs: 1 – 3
4. Connection power supply unit 12 V
Operation Manual ENG
5