Aqua Medic 83416004 Instrukcja obsługi - Strona 5

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Jednostka sterująca Aqua Medic 83416004. Aqua Medic 83416004 19 stron.

Programmable light control with three control outputs for one spot each with two channels (Aqua

Medic LEDspot and LED FA).

Technical Data

- 12 V DC safety voltage

- dimensions: 11.0 x 6.0 x 2.5 cm

Unpacking

On unpacking, please check the light control immediately for any damage. In case of any problems, please contact

your dealer directly.

Included in shipment



spot control



power supply unit

A 'Y'-cable for connecting two lights to one light connection is available as an accessory.

Safety instructions

When working in the aquarium, always disconnect all units from the power supply system before putting your

hands into the water. Connect all units to the mains via a residual current device with a maximum residual

current of 30 mA.

Suitable for indoor use only.

Protect the power supply and controller from moisture, splash and condensate.

Not suitable as a toy for children.

Installation

5.1. Programming

The spot control may only be connected to the designated socket (pict. No. 1). The internal battery will need to

be charged before use. After charging, the controller can be switched on independently from the light by pressing

the "M" and "OK" buttons simultaneously.

Fig. 1: spot control connections: 1 – 3: control outputs: 1 – 3

4. Connection power supply unit 12 V

Operation Manual ENG