Avonic CM-CON100 사용자 설명서 - 페이지 12

{카테고리_이름} Avonic CM-CON100에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Avonic CM-CON100 16 페이지. Ptz camera controller
Avonic CM-CON100에 대해서도 마찬가지입니다: 사용자 설명서 (12 페이지), 사용자 설명서 (10 페이지), 사용자 설명서 (13 페이지), 사용자 설명서 (11 페이지)

페이지 인쇄

Setup Menu

Press

to enter the Setup menu. Fill in the "ADMIN PIN". The initial ADMIN PIN is "111111".

The camera setting screen will show up. Use the joystick up and down to scroll through the menu features.

Move the stick to the right to enter the menu features and move the joystick to the left to leave the menu

features. It is also possible to use the

picture below:

1. Camera Setting

Setting

Functionality

Camera ID**

Sets unique Camera Identification number

Protocol Setting

Sets camera control protocol

Baud Rate

Sets the rate at which information is send

between controller and camera

Address**

Sets a specific (protocol) address for a

camera.

Increment*

Batches program camera's in the system

with the same baudrate, protocol for

multiple camera's. So you can control

multiple camera's at the same time.

* Note that the address increment between to sequental camera's. For example, if the current camera address

is 1 and the increment is 2, then the next camera address is 3.

** Note also that it is very easy to confuse (Protocol) address, Camera ID and the SET/CALL functionality! (see page 11)

Keep always in mind in which feature and menu you are making changes.

2. Time Setting

Time Setting

Move the joystick down and right to enter the Time Setting menu.

Move

to change the numbers and

Press

to save the time.

www.avonic.com

button to leave a menu feature, or delete a wrong insert. See the

Hours / Minutes / Seconds

Operation

Move the joystick to the right to enter the Camera Setting

menu. The

: appear on the screen. This will set the

Camera ID. Press 1 - 255 to set the ID and press

Move

to change the protocol setting (VISCA,

VISCA DC, PELCO D, PELCO P) and press

Move

to change the Baud Rate (2400, 4800, 9600,

19200, 38400) and press

Standard "'1", but you can set it between 1 - 255.

After you set the Camera Address, press SHIFT to enter

the increment menu. Input a number within 1~20,

press

to confirm.

to change hours, minutes and seconds.