CP Electronics EBDSPIR 제품 설명서 - 페이지 3

{카테고리_이름} CP Electronics EBDSPIR에 대한 제품 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. CP Electronics EBDSPIR 4 페이지. Ceiling presence detector
CP Electronics EBDSPIR에 대해서도 마찬가지입니다: 제품 설명서 (2 페이지), 설치 매뉴얼 (16 페이지)

페이지 인쇄

nd the time to minimum.

uld come on immediately.

still and wait for the load to switch off

nutes).

when movement is detected.

ntil the level of natural daylight is just

Starting with the LUX control fully clock-

urn the control anti-clockwise until the

he LUX control is at maximum then the

occupancy.

LOAD DOES NOT COME ON

Check to see if the live supply to the circuit is good. Strap across

the L and LIVE OUT terminal to turn the load on.

If the supply and wiring are good, check the LUX level setting.

Increase the LUX level setting to allow the controller to turn on at

higher ambient natural light level.

If the detection range is smaller than expected, check the dia-

gram above. Rotating the sensor slightly may improve the range.

LIGHTS DO NOT GO OFF

Ensure that the area is left unoccupied for longer than the se-

lected timer setting.

Make sure that the sensor is not adjacent to circulating air, heat-

ers or lamps.

Fault Finding