CP Electronics EBDSPIR 제품 설명서 - 페이지 2

{카테고리_이름} CP Electronics EBDSPIR에 대한 제품 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. CP Electronics EBDSPIR 4 페이지. Ceiling presence detector
CP Electronics EBDSPIR에 대해서도 마찬가지입니다: 제품 설명서 (2 페이지), 설치 매뉴얼 (16 페이지)

페이지 인쇄

FLUSH FIXING

Warning - be careful bending

springs when mounting unit.

SURFACE FIXING

Installation



The detector should be sited so that the occupants of the room fall

inside the detection pattern shown overleaf, at a recommended height of

2.8m on the ceiling. Note that the lower the sensor is installed the

smaller the detection range will be, subject to the parameters shown on

the diagram.



Avoid direct sunlight entering the sensor.



Do not site within 1m of forced air heating

or ventilation.



Do not site within 1m of any lighting.



Do not fix to a vibrating surface.



Wire the product using the connector using the diagram on the front

page.



Mount using one of the two options above.



To switch from more than one position simply wire two or more units in

parallel.

Hole Ø64mm

50mm or 60mm fixing centres

Pull out spring tab and rotate

spring arm as shown



Set the LUX level to maximum a



Power the unit up—the load sho



Vacate the room or remain very

(should take no more than 2 min



Check that the load switches on



To set the final LUX level wait un

enough that lighting is required.

wise (at minimum), very slowly t

lights come on. Note that when t

lights will always come on with o



Set the time required.