CP Electronics EBDSPIR Посібник з експлуатації - Сторінка 2
Переглянути онлайн або завантажити pdf Посібник з експлуатації для Датчики безпеки CP Electronics EBDSPIR. CP Electronics EBDSPIR 4 сторінки. Ceiling presence detector
Також для CP Electronics EBDSPIR: Посібник з експлуатації (2 сторінок), Посібник з монтажу (16 сторінок)
Друкувати сторінку
FLUSH FIXING
Warning - be careful bending
springs when mounting unit.
SURFACE FIXING
Installation
The detector should be sited so that the occupants of the room fall
inside the detection pattern shown overleaf, at a recommended height of
2.8m on the ceiling. Note that the lower the sensor is installed the
smaller the detection range will be, subject to the parameters shown on
the diagram.
Avoid direct sunlight entering the sensor.
Do not site within 1m of forced air heating
or ventilation.
Do not site within 1m of any lighting.
Do not fix to a vibrating surface.
Wire the product using the connector using the diagram on the front
page.
Mount using one of the two options above.
To switch from more than one position simply wire two or more units in
parallel.
1
Hole Ø64mm
1
50mm or 60mm fixing centres
2
2
Pull out spring tab and rotate
spring arm as shown
Set the LUX level to maximum a
Power the unit up—the load sho
Vacate the room or remain very
(should take no more than 2 min
Check that the load switches on
To set the final LUX level wait un
enough that lighting is required.
wise (at minimum), very slowly t
lights come on. Note that when t
lights will always come on with o
Set the time required.