Avonic AV-CON300 사용자 설명서 - 페이지 13

{카테고리_이름} Avonic AV-CON300에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Avonic AV-CON300 16 페이지. Ptz camera controller
Avonic AV-CON300에 대해서도 마찬가지입니다: 사용자 설명서 (13 페이지), 빠른 시작 매뉴얼 (2 페이지)

페이지 인쇄

Press the Zoom Rocker Button to Wide to the max and then press Reset

Operation

1. Boot

Plug in the keyboard power supply, monitor will display the default number CH1 CAM 1.

2. Select the camera number

Select the channel of the camera, then press ADD button and the Position Number key of the desired

camera to control.

3. PTZ operation

The Pan, Tilt and Zoom operations can be controlled by the joystick. In addition, the Zoom Rocker

Button can be used at the same time. The speed of the action can be fine-tuned by PTZ/ZOOM Speed

knob.

The focus can be automatically set with the AUTO button or manually set NEAR of FAR by the FOCUS

knob.

4. Set preset

Set the camera in desired position. Then press PRESET (key light on) and the position key number.

Press PRESET again (key light off)

5. Call preset

Press the Position Key of the desired preset.

6. Delete preset

Then press RESET (key light on) and the position key number. Choose another Preset to delete or

press RESET again (key light off)

7. Exposure mode selection

Press "AE AUTO" button to trigger auto exposure mode;

Rotate the "BRIGHT" knob that triggers the brightness priority, which can adjust the brightness of the

camera, "+" to increase the brightness, "-" to reduce the brightness;

Rotate the "IRIS" knob that triggers the aperture priority, which can adjust the aperture of the

camera, "+", and "-" to reduce the aperture;

8. White balance mode selection

Press the "WBC MODE" button to cycle the white balance modes ("WBC AUTO", "INDOOR",

"OUTDOOR", "ONE PUSH", "ATW", "OUT", "MANUAL");

Rotate the "R" knob that triggers the manual white balance mode, which can adjust the depth of the

red, "+" the red becomes darker, and the "red" becomes lighter;