Avonic AV-CON300 Посібник користувача - Сторінка 13
Переглянути онлайн або завантажити pdf Посібник користувача для Контролер Avonic AV-CON300. Avonic AV-CON300 16 сторінок. Ptz camera controller
Також для Avonic AV-CON300: Посібник користувача (13 сторінок), Посібник із швидкого старту (2 сторінок)
Press the Zoom Rocker Button to Wide to the max and then press Reset
Operation
1. Boot
Plug in the keyboard power supply, monitor will display the default number CH1 CAM 1.
2. Select the camera number
Select the channel of the camera, then press ADD button and the Position Number key of the desired
camera to control.
3. PTZ operation
The Pan, Tilt and Zoom operations can be controlled by the joystick. In addition, the Zoom Rocker
Button can be used at the same time. The speed of the action can be fine-tuned by PTZ/ZOOM Speed
knob.
The focus can be automatically set with the AUTO button or manually set NEAR of FAR by the FOCUS
knob.
4. Set preset
Set the camera in desired position. Then press PRESET (key light on) and the position key number.
Press PRESET again (key light off)
5. Call preset
Press the Position Key of the desired preset.
6. Delete preset
Then press RESET (key light on) and the position key number. Choose another Preset to delete or
press RESET again (key light off)
7. Exposure mode selection
Press "AE AUTO" button to trigger auto exposure mode;
Rotate the "BRIGHT" knob that triggers the brightness priority, which can adjust the brightness of the
camera, "+" to increase the brightness, "-" to reduce the brightness;
Rotate the "IRIS" knob that triggers the aperture priority, which can adjust the aperture of the
camera, "+", and "-" to reduce the aperture;
8. White balance mode selection
Press the "WBC MODE" button to cycle the white balance modes ("WBC AUTO", "INDOOR",
"OUTDOOR", "ONE PUSH", "ATW", "OUT", "MANUAL");
Rotate the "R" knob that triggers the manual white balance mode, which can adjust the depth of the
red, "+" the red becomes darker, and the "red" becomes lighter;
www.avonic.eu
13