Aqua One Maxi 103 사용자 설명서 - 페이지 9
{카테고리_이름} Aqua One Maxi 103에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Aqua One Maxi 103 12 페이지. Maxi series powerhead
페이지 인쇄
Installation 105/106
All Aqua One Maxi Power Heads come fully
assembled and are ready to use.
1. The 105 and 106 power heads come
supplied with 1 x 21mm inlet adapter and 1 x
19mm outlet adapter.
a) If no attachment is required simply place
the power head in the aquarium and fasten to
the glass using the suction cups.
b) If the power head is to be used in a sump
attach the 19mm outlet and use 19mm hose
to run from the outlet of the pump to the
aquarium. For extra security a good quality
stainless steel clamp should be used to secure
the hose to the outlet.
c) If the power head is to be used to run an
under gravel filter remove the pre filter and
attach the 21mm inlet adapter to the base of
the power head, then sit the power head in
the aquarium with the inlet attached to the
up lift of the under gravel filter and attach the
power head to the wall of the aquarium with
the suction cups.
Fig 1
Maintenance 105/106
Clean the impeller at least once a month.
Refer to the "Know You Filter" page for help
with the following procedure.
1. Remove the power head from the aquarium
Fig 2
and take it to the sink.
2. Grasp the motor with one hand and the pre
filter with the other and gently pull apart.
3. Turn the lock anti clock wise to remove then
pull the impeller cover off to gain access to the
impeller.
4. Pull impeller from the motor and rinse
properly. Use an Aqua One double ended pipe
brush to clean the impeller and the impeller
well and also any of the outlet options that are
being used.
5. Put the power head back together and
return to the aquarium. Ensure your hand is
not wet, plug in at the power supply and turn
Fig 3
on.
9
Fig 4