Billi Quadra 4100 설치 매뉴얼 - 페이지 3

{카테고리_이름} Billi Quadra 4100에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Billi Quadra 4100 12 페이지. Tower dispenser
Billi Quadra 4100에 대해서도 마찬가지입니다: 설치 매뉴얼 (8 페이지)

페이지 인쇄

Installation guide

Billi Quadra – Firewall Tower

Installation Requirements – Quadra

Components for Billi Quadra Compact, 420, 440, 460, 4100 & 4180 Models

Before commencing installation, ensure you have the following:

1. Underbench module

2. Dispenser with tubing

3. Tube spring clamps x 3

4. 600mm flexible braided hose

5. ½ inch drill bit (not included)

6. Drain fittings including John Guest fittings

7. 3/8 tube connected with adapter to 3/16 black tube

8. Filter Cartridge (installed)

9. User guide

10. Warranty Registration Card

11. Warning label

Determine Unit Location

Plan the installation. Dispenser tube lengths, position of power and water outlets, required air space

around the under bench module and access for service must be considered before cutting tube lengths.

Refer to Diagrams 3 and 4 for clearances around the dispenser and unit.

Unit must be installed horizontally with plastic vent panel facing the front of cupboard. The Quadra is

designed for internal installation only.

Model

Quadra Compact

Quadra 400 Models

Water Supply

The Quadra must only be connected to a cold water supply. A ½" BSP stop tap (not supplied) is to be

installed in an easily accessible position within 600mm from the Quadra water supply inlet. The Quadra

incorporates a certified pressure limiting and backflow prevention device. Do not fit an additional

pressure limiting valve.

Dynamic inlet supply pressure: Min. 250 kPa, max. 500 kPa*

Supply Temperature: min. 5°C max. 30°C.

*Where supply pressure is greater then 500kPa a PLV must be fitted. Billi recommends PLVs with anti-

hammer properties.

Do not install with water that is microbiologically unsafe or with water of unknown quality

without adequate disinfection before or after the system.

Systems certified for cyst reduction may be used on disinfected water that may contain

filterable cysts.

Power Requirements

3 pin GPO

required. A dedicated circuit should be provided and must be fitted with an earth

leakage protection device (RCD). An externally fitted RCD device is acceptable.

Quadra Compact, 420, 440, and 460 require a 10 amp rating.

Quadra 4100 requires a 15 amp rating.

Quadra 4180 requires a 20 amp rating.

All Quadra models are supplied with a 1 metre flex cord and plug.

Height

340mm

Width

Depth

315mm

365mm

315mm

465mm