Billi B-3000 사용자 설명서 - 페이지 4
{카테고리_이름} Billi B-3000에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Billi B-3000 8 페이지.
Billi B-3000에 대해서도 마찬가지입니다: 설치 매뉴얼 (4 페이지)
페이지 인쇄User guide
Billi B-3000.
Filter Cartridges Service Interval
Periodic replacement of your Billi B-3000
filter cartridge is necessary to maintain the
sparkling freshness of your drinking water .
Your Billi Representative will advise you of
an appropriate service interval . As a guide,
the filters should be serviced twice yearly .
In areas where water supply has a high level
of sediment, more frequent replacement of
filter cartridges may be necessary . This will
become evident when a significant drop in
delivery flow rate occurs .
4
Filter Cartridge Replacement
When you receive your replacement
cartridges, follow the procedure as
outlined below:
1 . Turn off water supply to unit .
2 . Remove front panel to unit .
3 . Turn temperature control to OFF
4 . Open tap to release any pressure .
5 . Close tap .
6 . Grasp the bottom of the filter and pull
towards yourself slowly . The top of the
filter is in a hinged cradle assembly .
It should stop after approximately
30 degrees of travel .
7 . The filter can now be released from the
holding cradle by pulling down on the filter .
8 . Take care not to spill water in the base
of the tray . If so wipe gently with blotting
paper .
9 . Install new filter into the same location
by pushing up into the cradle all the way .
10 . Push filter forward until upright and
locked in place .
11 . Turn water supply to unit on .
12 . Open tap again .
13 . Run water for 2-3 minutes to flush all
air out and condition the filter .
14 . Close tap .
15 . Check for any leaks from around the filter,
hosing or pipe work .
16 . Turn temp control to ON & set temperature
to desired level .
17 . Close front cover .