Billi B-3000 Руководство пользователя - Страница 4

Просмотреть онлайн или скачать pdf Руководство пользователя для Диспенсер Billi B-3000. Billi B-3000 8 страниц.
Также для Billi B-3000: Руководство по установке (4 страниц)

Печатать страницу
User guide
Billi B-3000.
Filter Cartridges Service Interval
Periodic replacement of your Billi B-3000
filter cartridge is necessary to maintain the
sparkling freshness of your drinking water .
Your Billi Representative will advise you of
an appropriate service interval . As a guide,
the filters should be serviced twice yearly .
In areas where water supply has a high level
of sediment, more frequent replacement of
filter cartridges may be necessary . This will
become evident when a significant drop in
delivery flow rate occurs .
4

Filter Cartridge Replacement

When you receive your replacement
cartridges, follow the procedure as
outlined below:
1 . Turn off water supply to unit .
2 . Remove front panel to unit .
3 . Turn temperature control to OFF
4 . Open tap to release any pressure .
5 . Close tap .
6 . Grasp the bottom of the filter and pull
towards yourself slowly . The top of the
filter is in a hinged cradle assembly .
It should stop after approximately
30 degrees of travel .
7 . The filter can now be released from the
holding cradle by pulling down on the filter .
8 . Take care not to spill water in the base
of the tray . If so wipe gently with blotting
paper .
9 . Install new filter into the same location
by pushing up into the cradle all the way .
10 . Push filter forward until upright and
locked in place .
11 . Turn water supply to unit on .
12 . Open tap again .
13 . Run water for 2-3 minutes to flush all
air out and condition the filter .
14 . Close tap .
15 . Check for any leaks from around the filter,
hosing or pipe work .
16 . Turn temp control to ON & set temperature
to desired level .
17 . Close front cover .