AVP Synthesizer MBS-100 사용자 설명서 - 페이지 6
{카테고리_이름} AVP Synthesizer MBS-100에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AVP Synthesizer MBS-100 8 페이지. Monophonic
페이지 인쇄LFO LEVEL control allows to set the amount of modulation applied to the filter via
the low-frequency oscillator (LFO).
RATE control allows to adjust the frequency of the LFO while the WAVE switch -
selection of two available waveforms (square or triangle).
ATTACK, DECAY, SUSTAIN and RELEASE controls allows to shape the envelope of
VCA, while the DISTORTION switch and control allows to adjust the depth of the
distortion effect.
VOLUME control allows to adjust the volume level of MBS-100.
In order to start working with MBS-100 the POWER switch should be turned
to On position.
In order to set one of 16 MIDI channels on MBS-100 use the button MIDI located
in the OSC section.
In order to set the channel hold down the MIDI button while turning the POWER
on. Then by pressing on the same MIDI button you can select the needed channel
in accordance with the table below. Each subsequent pressing of the MIDI button
will turn on a specific combination of LEDs 1, 2, 3, 4 which corresponds to a
specific MIDI channel.
MIDI
CH
1
2
3
4
LED
№
2
3
2,3
1
After choosing the required MIDI channel, press ENTER button which will save the
MIDI setting.
LFO Section
VCA Section
Powering on MBS-100
MIDI channel selection
5
6
7
8
9
1,2
1,3
1,2,3
4
2,4
10
11
12
13
3,4
2,3,4
1,4
1,2,4
6
14
15
16
OMNI
1,3,4
1,2,3,4
NO
1,2,3,4