AVP Synthesizer MBS-100 Manual do utilizador - Página 6
Procurar online ou descarregar pdf Manual do utilizador para Sintetizador AVP Synthesizer MBS-100. AVP Synthesizer MBS-100 8 páginas. Monophonic
Imprimir páginaLFO LEVEL control allows to set the amount of modulation applied to the filter via
the low-frequency oscillator (LFO).
RATE control allows to adjust the frequency of the LFO while the WAVE switch -
selection of two available waveforms (square or triangle).
ATTACK, DECAY, SUSTAIN and RELEASE controls allows to shape the envelope of
VCA, while the DISTORTION switch and control allows to adjust the depth of the
distortion effect.
VOLUME control allows to adjust the volume level of MBS-100.
In order to start working with MBS-100 the POWER switch should be turned
to On position.
In order to set one of 16 MIDI channels on MBS-100 use the button MIDI located
in the OSC section.
In order to set the channel hold down the MIDI button while turning the POWER
on. Then by pressing on the same MIDI button you can select the needed channel
in accordance with the table below. Each subsequent pressing of the MIDI button
will turn on a specific combination of LEDs 1, 2, 3, 4 which corresponds to a
specific MIDI channel.
MIDI
CH
1
2
3
4
LED
№
2
3
2,3
1
After choosing the required MIDI channel, press ENTER button which will save the
MIDI setting.
LFO Section
VCA Section
Powering on MBS-100
MIDI channel selection
5
6
7
8
9
1,2
1,3
1,2,3
4
2,4
10
11
12
13
3,4
2,3,4
1,4
1,2,4
6
14
15
16
OMNI
1,3,4
1,2,3,4
NO
1,2,3,4