AVP Synthesizers QUADWAVE 사용자 설명서 - 페이지 4

{카테고리_이름} AVP Synthesizers QUADWAVE에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AVP Synthesizers QUADWAVE 4 페이지. Avp synthesizers

⑧ POWER section

⑨ OUTPUTS LEFT/RIGHT

For connecting to external amp, mixer or soundcard.

⑩ CV INPUT of PHASER

Allows to manually control the modulation of the phaser.

⑪ INPUTS MAIN and DELAY 1, 2

Main input allows to process both phaser and 1, 2 delays simultaneously.

Delay 1, 2 input allows to process 2 signals separately.

To use the QUADWAVE MULTI FX in phaser → delay mode, you need to connect

a mono signal source to the INPUTS / MAIN jack, and the output cables to the

OUTPUTS / LEFT, RIGHT jacks on the back of the device. If you want to use the

delays separately, you must connect a mono source to the INPUTS / DELAY1 or

INPUTS / DELAY2 jack, or two sources to both of these jacks. In this case, the

phaser effect will not be used.

Note: DELAY2 has a self-oscillation mode of the delayed signal repeats. The signal

can rise at certain levels of the REPEATS controls (near max level). Therefore, we

advise to be very careful with sound amplifying equipment and always make sure

that the repeats on the Delay 2 are set cautiously.