AVP Synthesizers QUADWAVE Kullanıcı Kılavuzu - Sayfa 4
Sentezleyici AVP Synthesizers QUADWAVE için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. AVP Synthesizers QUADWAVE 4 sayfaları. Avp synthesizers
⑧ POWER section
⑨ OUTPUTS LEFT/RIGHT
For connecting to external amp, mixer or soundcard.
⑩ CV INPUT of PHASER
Allows to manually control the modulation of the phaser.
⑪ INPUTS MAIN and DELAY 1, 2
Main input allows to process both phaser and 1, 2 delays simultaneously.
Delay 1, 2 input allows to process 2 signals separately.
To use the QUADWAVE MULTI FX in phaser → delay mode, you need to connect
a mono signal source to the INPUTS / MAIN jack, and the output cables to the
OUTPUTS / LEFT, RIGHT jacks on the back of the device. If you want to use the
delays separately, you must connect a mono source to the INPUTS / DELAY1 or
INPUTS / DELAY2 jack, or two sources to both of these jacks. In this case, the
phaser effect will not be used.
Note: DELAY2 has a self-oscillation mode of the delayed signal repeats. The signal
can rise at certain levels of the REPEATS controls (near max level). Therefore, we
advise to be very careful with sound amplifying equipment and always make sure
that the repeats on the Delay 2 are set cautiously.
www.avpsynth.com