AVPro Edge AC-EX70-UHD-KIT 빠른 시작 매뉴얼 - 페이지 2

{카테고리_이름} AVPro Edge AC-EX70-UHD-KIT에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AVPro Edge AC-EX70-UHD-KIT 4 페이지. Ultra slim 4k hdmi via hdbaset 70 meter extender
AVPro Edge AC-EX70-UHD-KIT에 대해서도 마찬가지입니다: 사용자 설명서 (19 페이지)

페이지 인쇄

AC-EX70-UHD-R

LED Indicators (see images below for unit orientation and led location)

POWER – The receiver is powered identical to the transmitter. At the rear of the unit, it may be

power is connected correctly and the unit is active. If the LED is not illuminated, check where power is

applied. If the power supply is connected to the AC-EX70-UHD-T, verify the RJ-45 connections for the

category cable are intact.

SIGNAL – As with the AC-EX70-UHD-T, a

from the led indicates proper hdmi sync; continuous flashing indicates sync has not been made and

no image may be present.

INSTALLATION

1. Connect category cable into the hdbaset output on the transmitter to the HDBaseT input on the

receiver.

2. Connect the 48v power supply to the molex power socket at either the transmitter or receiver.

3. Connect an HDMI cable to the source output port, then connect this HDMI cable to the

transmitter HDMI input port. AVPro Edge recommends HDMI cables no shorter than 2 meters in

length. HDMI cables less than 2 meters challenge the HDCP timing check and the shorter distance

may prevent sync from taking place.

4. Connect an HDMI cable to the display input port, then connect this HDMI cable to the receiver

HDMI output port.

RS232 DIP SWITCH CONFIGURATION

•

The dip switch default is "normal", which positions the switch to the

right. This is the standard operating mode and allows for RS-232

pass through.

•

Positioning the dip switch to the left is the program mode and for

updating only. Commands will no pass through in this position.

IR CONFIGURATION

There are three modes for IR use. AVPro Edge recommends using the IR emitter from the kit and

refrain from using "flashing" IR emitters as they may not function properly or fail prematurely.

1. From the Source/Transmitter End: connect an ir sensor to the ir-in port on the AC-EX70-UHD

transmitter to send an ir command to the AC-EX70-UHD-R. On the receiver, connect an IR

emitter to the IR-out port and affix to the intended device.

2. From the Destination/Receiver End: connect an ir sensor to the IR-in port on the AC-EX70-

UHD-R. On the transmitter, connect an IR emitter to the IR-out port and affix to the intended

device.

BLUE

led provides status information of the unit. Solid blue

RED

indicates