AVPro Edge AC-EX70-UHD-KIT Посібник із швидкого старту - Сторінка 2
Переглянути онлайн або завантажити pdf Посібник із швидкого старту для Подовжувач AVPro Edge AC-EX70-UHD-KIT. AVPro Edge AC-EX70-UHD-KIT 4 сторінки. Ultra slim 4k hdmi via hdbaset 70 meter extender
Також для AVPro Edge AC-EX70-UHD-KIT: Посібник користувача (19 сторінок)
Друкувати сторінку
AC-EX70-UHD-R
LED Indicators (see images below for unit orientation and led location)
POWER – The receiver is powered identical to the transmitter. At the rear of the unit, it may be
powered by the 48v power supply directly, or via the connecting category cable.
power is connected correctly and the unit is active. If the LED is not illuminated, check where power is
applied. If the power supply is connected to the AC-EX70-UHD-T, verify the RJ-45 connections for the
category cable are intact.
SIGNAL – As with the AC-EX70-UHD-T, a
from the led indicates proper hdmi sync; continuous flashing indicates sync has not been made and
no image may be present.
INSTALLATION
1. Connect category cable into the hdbaset output on the transmitter to the HDBaseT input on the
receiver.
2. Connect the 48v power supply to the molex power socket at either the transmitter or receiver.
3. Connect an HDMI cable to the source output port, then connect this HDMI cable to the
transmitter HDMI input port. AVPro Edge recommends HDMI cables no shorter than 2 meters in
length. HDMI cables less than 2 meters challenge the HDCP timing check and the shorter distance
may prevent sync from taking place.
4. Connect an HDMI cable to the display input port, then connect this HDMI cable to the receiver
HDMI output port.
RS232 DIP SWITCH CONFIGURATION
•
The dip switch default is "normal", which positions the switch to the
right. This is the standard operating mode and allows for RS-232
pass through.
•
Positioning the dip switch to the left is the program mode and for
updating only. Commands will no pass through in this position.
IR CONFIGURATION
There are three modes for IR use. AVPro Edge recommends using the IR emitter from the kit and
refrain from using "flashing" IR emitters as they may not function properly or fail prematurely.
1. From the Source/Transmitter End: connect an ir sensor to the ir-in port on the AC-EX70-UHD
transmitter to send an ir command to the AC-EX70-UHD-R. On the receiver, connect an IR
emitter to the IR-out port and affix to the intended device.
2. From the Destination/Receiver End: connect an ir sensor to the IR-in port on the AC-EX70-
UHD-R. On the transmitter, connect an IR emitter to the IR-out port and affix to the intended
device.
BLUE
led provides status information of the unit. Solid blue
RED
indicates